Floor Support Systems in Murfreesboro, TN
Two housing stocks in one county, two kinds of soft floor
About an hour and ten minutes from our shop. Free assessment, a measured topo report of the floor, and a written estimate for the framing work.
What we find under houses in Murfreesboro
Rutherford County has century-old homes near the square and subdivisions finished last year, and the floors fail differently in each. In the older housing it is the familiar sequence: a post standing on damp soil loses its base, the girder above it drops, and the joists follow. In the newer housing the framing is engineered and correctly sized, and the problem is nearly always a support that was left out or a member that a later trade cut through.
Murfreesboro also has a large rental and student housing stock around the university, and houses that have been through many tenants have usually been through many quick repairs. Under those floors we find jack posts set on a paving slab, a beam sistered with a board that is doing nothing structural, and shims stacked where a proper base pad belongs. None of that is holding the way somebody hoped it would.
We measure before we plan, because on a house with several generations of repair underneath, the elevations are the only honest account of what has moved. Adjustable steel supports on engineered polymer base pads replace what has failed or was never adequate, supplemental girders shorten spans, and sistered lumber restores joists that have lost depth. The recovery is staged so the finishes upstairs travel with the floor.
Everything we do in Murfreesboro- A soft spot underfoot in the kitchen or a hallway
- Dishes rattling in a cabinet when someone walks past
- A floor that slopes enough for a ball to roll on its own
- Gaps opening between the floor and the baseboard
- Tile grout cracking in a line across a room
- Interior doors that will not latch the way they used to
None of that is a diagnosis of your house. What your home actually needs comes from the assessment and the measured scan on your own crawlspace.
The same checklist on every Murfreesboro job
Every floor support work we do in Murfreesboro, TN follows the same sequence. A soft spot in the kitchen and a sloping hallway can come from completely different failures, and the wrong repair on the wrong cause does not hold. The assessment matters more than the product.
Elevations measured first
The FoundationScan® topo report shows where the floor sits now, so the repair has a measured target elevation to work to.
Adjustable steel supports
Set on engineered polymer base pads sized for the load. Adjustable means the floor can be fine-tuned later if it needs it.
Supplemental beams
Where a span is simply too long, a new girder shortens it and spreads the load across more support points.
Joist & beam repair
Rotted or overloaded joists and beams get sistered with new lumber, so the load has sound wood to carry it.
Rot cause addressed
New framing in a damp crawlspace starts down the same road as the old framing, so the moisture source is dealt with in the same visit.
Guaranteed stabilization
Stabilized at the measured elevation and checked against the scan. Stay on the annual service call and we guarantee it holds.
Four steps, and you see the findings before the price
Free assessment
We go under the house, take moisture readings, elevations and measurements, and check every support. Takes as long as it takes.
Findings & written estimate
Photos and readings walked through with you, then a line-item price. Financing options if you want them.
Install
The same family crew that quoted the job does the work. Most crawlspace and waterproofing projects run 1–3 days.
Annual service call
$250 a year covers a service on the equipment we installed and a fresh FoundationScan® report, so changes are caught early. No contract required.
Murfreesboro questions we get asked
Our rental has a soft floor in one bedroom. How disruptive is the repair for tenants?
Not very. The work happens under the floor with access through the crawlspace, so nobody has to move out, and we can coordinate timing. Most floor repairs take a few days.
There's a jack post under our house on a paving slab. Is that doing anything?
Very little after a few years. A slab on soil settles along with everything around it, so the post ends up holding an elevation that has moved. Adjustable steel supports on engineered base pads replace it and get set to a measured target.
The floor slopes in the older part of the house and is fine in the newer part. Is that expected?
Around Murfreesboro it is common. Older sections sit on shallow footings over uncovered ground, and newer sections sit on modern framing over a graded pad. The elevations usually show a clear break at the join.
Can you tell whether it is the floor framing or the foundation?
That is one of the main things the assessment answers. Soft floors with no cracking in the walls point at the framing. A sloping floor with cracked walls points at the foundation. We measure the floor and read the walls in the same visit.
Do you do the work yourselves?
Yes, our own crews. The family that assesses the house and quotes the job is the one that does the installation, across the whole service area.
Floor Support Systems near Murfreesboro
Murfreesboro, TN sits about an hour and 10 minutes from our shop in Baxter, and we work the rest of Rutherford County and the Nashville Basin on the same runs.
All 33 towns we coverFree floor assessment in Murfreesboro
We measure the elevations, find what is carrying the floor now, and price the repair in writing. No cost, no obligation.
Family owned & operatedFree estimatesFinancing as low as 0%Annual service calls available